Home / Shop by part type / Wide Angle (C.V.) Shafts / WE67130

125 HP Wide Angle CV Shaft, Bare Implement End — 1 3/8" x 6 tractor end, 68"–107"

WE67130 · P675 series · Wide Angle CV Shaft, Bare Implement End

$3,100

Specification

Product family: Wide Angle (C.V.) Shafts
Series: P675
Tier: Upgrade
Position: Complete driveline
End yoke: Bare implement end, accepts standard yoke
Tractor spline: 1 3/8" x 6
Cross journal diameter: 36/42 mm (1.42/1.65")
Cross length: 89/104 mm (3.50/4.09")
Closed, cross to cross: 54" (137 cm)
Open, cross to cross: 93" (236 cm)
Closed length (collapsed): 68" (173 cm)
Open length (extended): 107" (272 cm)
Power at 540 rpm: 125 hp
Power at 1000 rpm: 200 hp
Decoded: Wide angle, bare implement end

Match the tractor, not the implement. The shaft’s rating must meet or exceed your tractor’s PTO horsepower. Undersize it and the driveline becomes the part that fails.

Check your PTO speed. This shaft is rated 125 hp at 540 rpm and 200 hp at 1000 rpm. Use the figure for the speed you actually run — they are not interchangeable.

Working it hard? Bare Co advise reducing the rated horsepower by 40% for severe conditions — shock loading, heavy or wet crop, stony ground.

Length

Closed is the shaft fully collapsed — its shortest. Open is fully extended — its longest. Your tractor and implement must sit inside that range at every point through the turn.

Cross to cross is measured between the centres of the two universal joints. Overall is the full length including the end yokes. Most machine specs quote cross to cross.

This shaft trims to length. Measure your machine at its shortest point — the shaft must not bottom out — then cut to suit. You can always take metal off; you cannot put it back.

Complete shaft. Bare Co page pto16 states the build explicitly: IH675130 + OHEP675130. Both halves already stocked. Dealer cost not yet captured.

OTHER OPTIONS IN THIS SERIES